Installed: setserial_2.17-14.diff.gz to dists/potato/main/source/base/setserial_2.17-14.diff.gz replacing setserial_2.17-13.diff.gz setserial_2.17-14.diff.gz to dists/woody/main/source/base/setserial_2.17-14.diff.gz replacing setserial_2.17-13.diff.gz setserial_2.17-14.dsc to dists/potato/main/source/base/setserial_2.17-14.dsc replacing setserial_2.17-13.dsc setserial_2.17-14.dsc to dists/woody/main/source/base/setserial_2.17-14.dsc replacing setserial_2.17-13.dsc setserial_2.17-14_i386.deb to dists/potato/main/binary-i386/base/setserial_2.17-14.deb replacing setserial_2.17-13.deb setserial_2.17-14_i386.deb to dists/woody/main/binary-i386/base/setserial_2.17-14.deb replacing setserial_2.17-13.deb -----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Format: 1.6 Date: Sat, 27 May 2000 17:45:48 +0100 Source: setserial Binary: setserial Architecture: source i386 Version: 2.17-14 Distribution: frozen unstable Urgency: low Maintainer: Gordon Russell <g.russell@dcs.napier.ac.uk> Description: setserial - Controls configuration of serial ports. Closes: 64703 Changes: setserial (2.17-14) frozen unstable; urgency=low . * The module.conf entries for pre-remove of modules in kerneld is a null operation, although previous releases of setserial makes use of this function, in the hope that one day it actually works. However, if you currently unload and then reload the serial.o module, you lose all your serial configuration details until you run /etc/init.d/setserial start I have made a simple change to the configuration, so that failure of pre-remove is detected, and the serial ports on a module reload are reconfigured to the configuration present imediately after serial configuration has completed. This is not as good as pre-remove actually working, but is probably sufficient for all but the most nit-picking people out there. If you change your serial configuration a lot during a single boot session, consider calling /etc/init.d/setserial modsave from cron every minute or two (or at least before a module autoclean occurs). (closes: #64703) Files: a8f9bf5f00c6b83a493d42d558edeae4 606 base required setserial_2.17-14.dsc af56099e95476e237f55d9cc30688134 22568 base required setserial_2.17-14.diff.gz fb962cf724e87bd29a7bb302c29b3b5c 34660 base required setserial_2.17-14_i386.deb -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.0.1 (GNU/Linux) Comment: For info see http://www.gnupg.org iEYEARECAAYFAjkv/9oACgkQsbjrHwXvAePrsACdFSqwjNeJ/Wiyh77ys2joth6I K0sAn3s/tG7wp8zptyujVPP/d90nbr3x =6h32 -----END PGP SIGNATURE-----